GRAPHTEC FC9000 Series - Page 176

7-26
5
Press the [1] key (TOOL 1-2).
TOOL OFFSET ADJ. screen is displayed.
6
Press the [2] key (TEST PATTERN).
The following message is displayed.
Supplement

It will return to TOOL OFFSET ADJ. screen
without changing the settings when you press
the [ESC] key (CANCEL).

Pressing the POSITION and [SLOW] keys
at the same time will move the tool carriage
slower.
7
Press the POSITION ( ) keys to move the tool carriage
to the position where the test pattern is plotted.
Move it inside of a cutting area greater than 50 mm on both
the X and Y axes.
8
&RQÀUPWKHWRROSRVLWLRQDQGSUHVVWKH>(17(5@NH\
Using the cutter plunger (Tool 1), plot a "+" mark.
Next, using the pen plunger (Tool 2), plot a "+" mark.
 :KHQSORWWLQJLVFRPSOHWHG7RRO,QWHUYDO$GMXVWPHQWVFUHHQLV
displayed.