GRAPHTEC FC9000 Series - Page 177

7-27
9
Using "+" plotted with the cutter plunger (Tool 1) as a
reference, measure how much the "+" cut by the pen plunger
(Tool 2) deviates. (For example, in the case shown in the
ÀJXUHLWLVGHYLDWHGLQWKH;GLUHFWLRQ<GLUHFWLRQVRHQWHU
X = + * mm, Y = - * mm.)
X mm
Y mm
"+" plotted with
the cutter plunger
(Tool 1)
"+" plotted with the
pen plunger (Tool
2)
10
Press the [3] key (X=+0.0mm).
7RRO,QWHUYDO$GMXVWPHQW;VFUHHQLVGLVSOD\HG
Supplement
You can set the range between -3.0 mm and
+3.0 mm.
11
Press the POSITION ( ) keys and increase or decrease the
setting value.
12
 &RQÀUPWKHVHWWLQJDQGSUHVV>(6&@NH\35(9,286
TOOL OFFSET ADJ. screen is displayed.
13
Press the [4] key (Y=+0.0mm).
7RRO,QWHUYDO$GMXVWPHQWVFUHHQLVGLVSOD\HG
Supplement
You can set the range between -3.0 mm and
+3.0 mm.
14
Press the POSITION ( ) keys and increase or decrease the
setting value.