GRAPHTEC FC9000 Series - Page 251

13-7
3
Press the [PAUSE/MENU] key.
MENU screen is displayed.
4
Press the [2] key (AXIS).
AXIS SETTING screen (1/1) is displayed.
5
Press the [1] key (AXIS POINT SETTING).
The following message is displayed.
Supplement
Pressing the POSITION and [SLOW] keys at the
same time will move the tool carriage slower.
6
Press the POSITION ( ) keys to move the tip of the tool
to the alignment mark position.
Move the tool to the position of alignment point 1 (Any point on the X
axis already plotted)
Supplement
It will return to default screen without scanning
when you press the [ESC] key (CANCEL).
7
&RQÀUPWKHWRROSRVLWLRQDQGSUHVVWKH>(17(5@NH\
Supplement
Pressing the POSITION and [SLOW] keys at the
same time will move the tool carriage slower.
8
Press the POSITION ( ) keys to move the tip of the tool
to the alignment mark position.
Move the tool to the position of alignment point 2 (Any point on the X
axis already plotted).