13-8
Supplement
It will return to default screen without scanning
when you press the [ESC] key (CANCELN).
9
&RQÀUPWKHWRROSRVLWLRQDQGSUHVVWKH>(17(5@NH\
Supplement
Pressing the POSITION and [SLOW] keys at the
same time will move the tool carriage faster.
10
Press the POSITION (
) keys to move the tip of the tool
to the alignment mark position.
Move the tool to the new origin point (Point you want to be the origin
point).
11
&RQÀUPWKHVHWWLQJDQGSUHVVWKH>(17(5@NH\6(7
The tilt angle of the X axis is calculated and the axis alignment is
performed. On completing it, it will return to default screen.
To Next Page
Loading...
