GRAPHTEC FC9000 Series - Initial Setting

A-14
A.5
Initial Setting
Menu items Setting item Initial value
TOOLS SETTING
(TOOL)
TOOL OFFSET ADJ. –
STEP PASS 1
OFFSET FORCE 7
OFFSET ANGLE 30
DATA SORTING OFF
CONDITION PRIORITY PROGRAM
TOOL SELECT COMMAND SETTING
ENABLED
TOOL UP MOVE
DISABLED
MOVING SPEED AUTO
TOOL UP HEIGHT NORMAL POSITION
BLADE WEAR ALARM SETUP OFF
INITIAL B. ANGLE POSITION 2mm BELOW
ARMS SETTING
(ARMS)
SCAN MODE MODE1
RECOMMENDED SETTINGS –
MARK LINE CHECK –
SENSOR OFFSET ADJ.(X) 0
SENSOR OFFSET ADJ.(Y) 0
MARK AUTO SCAN ON
SENSING SPEED 30cm/s
TEST ARMS SENSOR –
ARMS CROSSCUT OFF
MARK SCAN MODE OFF
AREA PARAMETERS
(AREA)
SCALE 1
ROTATE OFF
MIRROR OFF
AREA SET LOWER LEFT (DEFAULT)
AREA SET UPPER RIGHT (DEFAULT)
EXPAND (DEFAULT)
MEDIA SETTING
(MEDIA)
PRE FEEDFEED LENGTH 1m
AUTO PRE FEED OFF
AUTO PRE FEED FEED LENGTH 1m
PAGE LENGTH 200.0cm
INITIAL FEED OFF
FEED SPEED NORMAL POSITION
CROSS CUT FORCE 30
PANEL CUTTING OFF
DIVIDE LENGTH 100.0cm
TAKE-UP OFF
INTERFACE
(I/F)
COMMAND AUTO
HP-GL ORIGIN POINT LOWER LEFT
HP-GL MODEL EMULATED 7586
*3*/67(36,=( 0.100mm
RS-232C (SWITCHING SETTING NUMBERS) No.1
RS232C: FORWARDING CONDITION
BAUD RATE/DATA BIT/
PARITY/HARDWIRE HANDSHAKE
RS-232C No.1 : 9600/8/NONE//HARD
RS-232C No.2 : 9600/7/EVEN//HARD
RS-232C No.3 : 9600/8/EVEN/XonXoff
RS-232C No.4 : 9600/8/EVEN/XonXoff
LAN DHCP OFF
LAN IP 192.168.0.1
LAN SUBNET MASK 255.255.255.0
LAN GATEWAY 192.168.0.254
COMMAND ':',';' ENABLED
COMMAND 'W' TOOL UP
CIRCLE RESOLUTION DEFAULT