GRAPHTEC FC9000 Series - Page 395

A-15
Menu items Setting item Initial value
ADVANCE
(ADV.)
MOVE STEP 0.1mm
LANGUAGE SELECTION Select when initially turning on power
LENGTH UNIT Select when initially turning on power
BEEP FOR KEY OPE. ON
POSI. KEY SPEED + SLOW KEY 1cm/s
POSI. KEY SPEED 10cm/s
AP MODE DISABLED
PAUSE/MENU KEY SET TING PAUSE
USER KEY SETTING ENABLED
LCD CONTRAST 0
MEDIA SENSOR ENABLED
PUSH ROLLER SENSOR ENABLED
FAN POWER NORMAL POSITION
TEST
(TEST)
NO SETTINGS –
DATA LINK
(LINK)
DESTINATION USB DRIVE
START MARK AUTO SCAN OFF
COMMUNICATION TIME OUT 10sec
AUTOMATIC SKEW DETECTION 10mm
TOOL
SETTING
(Condition)
CONDITION 1 Condition No. Condition No. 1
TOOL CB09U
SPEED 30
FORCE 14
ACCELERATION 4
ASSIGN TOOL 1
TANGENTIAL MODE OFF
OVERCUT (START) 0
OVERCUT (END) 0
DISTANCE ADJUST OFF
INITIAL DOWN FORCE 0
CUT LINE PATTERN OFF
CONDITION 2 Condition No. Condition No. 2
TOOL PEN
SPEED/FORCE/ACCELERATION 30/12/4
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
CONDITION 3 Condition No. Condition No. 3
TOOL CB09U
SPEED/FORCE/ACCELERATION 30/12/4
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
CONDITION 4 Condition No. Condition No. 4
TOOL CB09U
SPEED/FORCE/ACCELERATION 20/17/3
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
CONDITION 5 Condition No. Condition No. 5
TOOL CB09U
SPEED/FORCE/ACCELERATION 80/14/8
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
CONDITION 6 Condition No. Condition No. 6
TOOL CB09U
SPEED/FORCE/ACCELERATION 10/22/2
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
CONDITION 7 Condition No. Condition No. 7
TOOL CB15U
SPEED/FORCE/ACCELERATION 5/30/1
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
CONDITION 8 Condition No. Condition No. 8
TOOL POUNCE
SPEED/FORCE/ACCELERATION 30/12/4
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
* Setting items and initial values may be changed.