GRAPHTEC FC9000 Series - Page 73

2-47
Supplement
See "Structure of Cutter Plunger" for blade
OHQJWKDGMXVWPHQWNQRE
6
$VLQVWUXFWHGWXUQWKHEODGHOHQJWKDGMXVWPHQWNQREWRWKH
left to fully retract the blade.
Blade
Supplement
$GMXVWPHQWLVRQO\SRVVLEOHIRUWKHFXWWHUSHQ
set in Tool Holder (Backward). It does not apply
to Tool Holder (Forward) . See "Attaching a Tool"
for instructions on setting.
7
Set the cutter plunger in Tool Holder (Backward).
8
Press the [ENTER] key.
The height is calculated by moving the tool up and down.
TO ACHIEVE THE TARFET LENGTH screen is displayed.
9
Press the [1] key (BLADE LENGTH TARGET).
BLADE LENGTH TARGET screen (TARGET) is displayed.
10
Press the POSITION ( ) keys and increase or decrease the
setting value.
11
 &RQÀUPWKHVHWWLQJVDQGSUHVVWKH(17(5NH\6(7
The Blade Length Target will be selected, and it will return to the TO
ACHIEVE THE TARGET LENGTH screen.