GRAPHTEC FC9000 Series - Page 74

2-48
Supplement
"T" is the target value of the blade length, and
"H" is the current blade height (amount).
7XUQLQJWKHEODGHOHQJWKDGMXVWPHQWNQRE
displays the number of turns and direction.
12
Press the [2] key (CHECK).
The height is calculated by moving the tool up and down.
7KHDPRXQWDQGGLUHFWLRQWRWXUQWKHDGMXVWPHQWNQRELVGLVSOD\HG
CAUTION
Depending on the loaded media, the blade
might sink in to the media, making accurate
measurement impossible.
13
 7XUQWKHEODGHOHQJWKDGMXVWPHQWNQREDQGDGMXVWWKHFXWWHU
blade length.
Current blade length is displayed by pressing the [2] key
&+(&.VRDGMXVWWKHEODGHOHQJWKXQWLOLWPDWFKHVWKH
thickness of the media.
14
Press the [ESC] key (END).
$GMXVWPHQWLVFRPSOHWHGDQGLWZLOOUHWXUQWR&21',7,21VHWWLQJVFUHHQ
(3/3).
15
Press the [COND/TEST] key.
I will be return to default screen. After completing the settings, press
[ENTER] key.