GRAPHTEC FCX2000 - Y Motor Belt

FCX2000-UM-251-9370 8-31
8 DISASSEMBLY AND ASSEMBLY
8.3.2 Y Motor Belt
How to detach the X Motor Belt
(1) Detach the rear Y bar end cover (Refer to the section 8.1.16.).
(2) Disconnect the Y motor cables from the Y relay board.
Y relay board
Y motor cables
Y motor
(3) Remove the four M4L8 cap screws holding the Y motor bracket assembly, and then detach it.
M4L8 cap screw
Y motor bracket assembly
(4) Detach the Y motor (Refer to the section 8.3.1.).
(5) Loosen the four M4L5 set screws holding the Y motor drive gear.
M4L5 set screw
Y motor drive gear