FCX2000-UM-251-9730 4-12
4.
OPER ATIONS
4.3 Replacing the Cutter Blade
PHP33-CB09-HS/PHP33-CB15-HS
(1) Remove the chuck from the plunger by using the plunger-cap
Hole
Chuck
Blade
Remove
Install
Plunger
Chuck
Plunger-cap
(2) Replace the blade of chuck.
Install the blade to the chuck straightly when the blade is installing to the chuck.
Push the blade hole part several times when the blade was not able to install to the chuck straightly.
And then install the blade to the chuck completely.
Blade hole part
(3) Install the chuck to the plunger after the blade was replaced.
Then tighten the chuck.
PHP33-CB09-HS/PHP33-CB15-HS
(1) Turn the chuck counterclockwise to remove the chuck from the plunger.
Plunger
Chuck
ø3.0 mm Blade and Spring
(2) Replace the blade and the spring of chuck.
(3) Install the chuck to the plunger after the blade was replaced.
Then tighten the chuck.
To Next Page
Loading...
