FCX2000-UM-251-9370 3-1
3 Description of Parts
3 Description of Parts
3.1 Plotter Nomenclature
The names of the plotter parts are as follows.
(2) Power switch
(1) Control panel
(13) Stand
(14) Emergency Stop Switch
(3) AC line inlet(15) USB memory
dedicated port
(4)
Vacuum hose
connection port (2 inch)
(5) Media stocker
(6) Writing panel
(10) USB interface connector
(11) RS-232C interface connector
(12) Network interface connector
(7) CHART HOLD key
(8) Tool carriage
(9) Y bar
Back side of the main body
(1) Control pane ........................................... Used to access various plotter functions.
(2) Power switch ..........................................Used to turn the plotter on and off.
(3) AC line inlet ............................................Inlet where the power cable is connected.
(4) Vacuum hose connection port ................ Connect to the blower with a hose. (2 inch) (VC model only)
(5) Media stocker .........................................Set a roll paper (media material) after passing the shaft through
the roll paper.
(6) Writing panel .......................................... Cutting/Plotting/Creasing work is performed on the panel.
(7) CHART HOLD key..................................Lamp lights up when the [CHART HOLD] key is pressed, you
can see that the electrostatic adsorption is functioning. Lamp
is turned off by pressing again, the electrostatic adsorption is
released. (ES model only)
(8) Tool carriage ...........................................Part to drive the cutter/pen.
(9) Y bar ....................................................... Holds the tool carriage; moves left/right.
(10) USB interface connector ........................ Used to connect the plotter to the computer with a USB interface
cable.
(11) RS-232C interface connector ................. Used to connect the plotter to the computer with a RS-232C
interface cable.
(12) Network (LAN) interface connector ........ The connector used when connecting this plotter with the
network (LAN)interface cable.
(13) Stand ...................................................... A stand to put the machine on.
(14) Emergency Stop Switch ......................... Press to stop the unit. Please use this in case of emergency.
(15) USB memory dedicated port .................. The port that is used only for the USB memory.
To Next Page
Loading...
