GRAPHTEC FCX2000 - Page 40

FCX2000-UM-251-9370 2-25
2 Setup procedure
(26) Connect the Warning Light cable as shown in the picture below.
(27) Attach the left rear cover of warning light by using the four M4L8 binding head screws.
M4L8 binding head screw
Left rear cover of warning light
(28) Conrming the warning light operation
Conrm the all Light on the warning light is lit (Green, Red, and Yellow) after the warning light was
installed.
•
Turn on the power for the FCX2000, and then conrm all Light on the warning light is lit.
•
The warning light test function is in the maintenance mode from the rmware version 2.10 (Page 5/5).
Conrm the warning light operation with one of above function.