GRAPHTEC FCX2000 - Error Messages In Hp-Gl Command Mode

FCX2000-UM-251-9370 10-9
10 TROUBLESHOOTING
10.5 Error Messages in HP-GL Command Mode
Error cord No. LCD Display Cause Solution
E03001 An unrecognizable
instruction was
executed.
Conrm the command
settings is not set to the
GP-GL.
Set the command settings to
the HP-GL.
E03002 Wrong number of
parameters were
specied.
Conrm the command
settings is not set to the
GP-GL.
Set the command settings to
the HP-GL.
E03003 An unusable parameter
was executed.
Conrm the command
settings is not set to the
GP-GL.
Set the command settings to
the HP-GL.
E03005 An unusable character
set was specied.
Specify usable character set.
E03006 Coordinates of command
specied out of cutting
area.
Execute coordinates within
the cutting area.
E03007 The data being input
exceeds the capacity
of the plotter's
downloadable character
buffer, polygon buffer,
etc.
This error will not display if
the application software was
programed correctly.
Conrm this to the vender of
application software.
E03010 Other output command
was executed while
executing an output
command.
E03011 An invalid byte was
received after ESC code.
E03012 Invalid byte was received
within device control
command.