GRAPHTEC FCX2000 - Operational Error

FCX2000-UM-251-9370 10-19
10 TROUBLESHOOTING
10.8 Operational Error
Error cord No. LCD Display Cause Solution
E05001 Data larger than the
buffer size cannot be
copied.
It can not use the copy mode.
E05002 There is no data to copy. Perform normal cutting by
sending the data, then use
the copy mode.
E05003 Media valid area to copy
is too small.
Use larger media.
Conrm the copy start
position.
E05006 Distance between the
bottom left and top right
of the AREA setting is
less than 10 mm.
Perform the AREA setting
again.
E05007 Test pattern for the TOOL
OFFSET ADJ. cannot
start plotting because
the start position is at the
edge of the media.
Set the start position inside
the media.
E05008 The external memory
(USB memory) is not
recognized.
Insert the external memory
(USB memory).
E05009 The bar code is not
detected.
Check at the printing state of
bar code and set the proper
bar code settings.
E05010 When the ROTATION is
enabled, the bar code
cutting function is not
available.
Set the ROTATION to
Disabled to use this bar code
cutting function.
E05011 When the REVERSE
CUTTING is enabled,
the bar code cutting
function is not available.
Set the REVERSE CUTTING
to Disabled to use this bar
code cutting function.
E05012 The appropriate le
cannot be found in the
external memory (USB
memory).
Save the appropriate le in
the external memory (USB
memory).
E05013 The START MARK is not
recognized.
Conrm the printing state of
bar code.
Move the tool carriage to the
START MARK.