GRAPHTEC FCX2000 - Pen Block

FCX2000-UM-251-9370 8-36
8 DISASSEMBLY AND ASSEMBLY
8.3.6 Pen Block
How to detach the Pen Block
(1) Detach the Y bar cover (Refer to the section 8.1.13.).
(2) Detach the pen block cover (Refer to the section 8.1.14.).
(3) Disconnect the MC exible cables and the registration mark sensor cables from the pen board.
Registration mark sensor cables
MC exible cables
Pen board
(4) Remove the two M4L6 binding head screws holding the pen block assembly, and then detach it.
Pen block assembly
M4L6 binding head screw
(5) The spare part of pen block assembly is not including the registration mark sensor boards.
Detach the registration mark sensor boards when the pen block assembly is replaced.