GRAPHTEC FCX2000 - Electrostatic Relay Board

8.7.2 Electrostatic relay board
How to detach the Electrostatic relay board
(1) Detach the right top cover (Refer to the section 8.1.5.).
(2) Disconnect the high voltage board cable from the relay connector of Electrostatic relay board.
(3) Disconnect the exible cable of electrostatic adhesion panel from the electrostatic relay board.
(4) Remove the four M3L6 binding head screws holding the electrostatic relay board, and then detach it.
M3L6 binding head screw
Electrostatic relay board
High voltage board
How to reinstall the Electrostatic relay board
(1) Reattach the electrostatic relay board in the reverse order in which it was detached.