FCX2000-UM-251-9370 8-68
8 DISASSEMBLY AND ASSEMBLY
8.8.2 Replacing the VC Panel
The VC Panel is attached to the honeycomb plate by the double-sided Adhesion tapes.
The 20 mm wide double-sided Adhesion tapes are put on the red part of VC Panel as shown in the picture
below.
How to peel off the VC Panel
(1) Detach the right top cover (Refer to the section 8.1.5.).
(2) Move the Y bar to the left end.
(3) Insert the thin at head screw driver to between the VC panel and the honeycomb plate, and then gently
peel off the VC panel from the honeycomb plate.
Don’t make any damage to the honeycomb plate when the thin at head screw driver is inserting.
How to place the VC Panel
(1) Clean the glue from the honeycomb plate.
(2) Put on the VC panel to same position which was installed.
(3) Put the VC panel to the honeycomb plate by the double-sided Adhesion tapes.
To Next Page
Loading...
