GRAPHTEC FCX2000 - Installing The Warning Light Option

FCX2000-UM-251-9370 2-11
2 Setup procedure
2.7 Installing the Warning Light Option
The Warning Light Option has the following three types.
Category Option Name Description Work content
Factory option OPH-A40 The warning light bracket
is installed.
• Installing the warning
light to bracket.
• Connecting the warning
light connector.
This option is installed by
service engineer, after the
FCX2000 was installed to
customer
OPH-A41 The warning light bracket
is not installed.
The control box is
corresponding for the
warning light option.
• Installing the warning
light bracket.
• Wiring the cables in the
control box.
• Installing the warning
light to bracket.
• Connecting the warning
light connector.
OPH-A42 The warning light bracket
is not installed.
The control box is not
corresponding for the
warning light option.
• Replacing the control
box.
• Installing the warning
light bracket.
• Wiring the cables in the
control box.
• Installing the warning
light to bracket.
• Connecting the warning
light connector.