GRAPHTEC FCX2000 - X-Axis Drive Part; Motor

FCX2000-UM-251-9370 8-14
8 DISASSEMBLY AND ASSEMBLY
8.2 X-Axis Drive Part
8.2.1 X Motor
How to detach the X Motor
(1) Detach the left top cover (Refer to the section 8.1.6.).
(2) Disconnect the X motor cables from the main board (Connector 11 and J17).
J11: X motor encoder cable
J17: X motor power cable
(3) Remove the four M4L8 binding head screws holding the X motor, and then detach it.
M4L8 binding head screw
X motor
(4) Detach the core from the X motor encoder cable.
(5) Loosen the two M4L5 set screws holding the X motor pulley, and then detach it.
M4L5 set screw
X motor
Core
X motor pulley