GRAPHTEC FCX2000 - Home Sensor Board

FCX2000-UM-251-9370 8-24
8 DISASSEMBLY AND ASSEMBLY
8.2.5 X Home Sensor Board
How to detach the X Home Sensor Board
(1) Detach the right rear corner cover (Refer to the section 8.1.2.).
(2) Detach the left rear corner cover (Refer to the section 8.1.4.).
(3) Detach the rear top cover (Refer to the section 8.1.11.).
(4) Detach the rear bottom cover (Refer to the section 8.1.12.).
(5) Remove the two M3L6 binding head screws holding the X home sensor board.
M3L6 binding head screw
X home sensor cable
X home sensor board
(6) Disconnect the X home sensor cable from the X home sensor board.
How to reinstall the X Home Sensor Board
(1) Reattach the X home sensor board in the reverse order in which it was detached.
(2) Move the Y bar to the X home sensor position and conrm the X home sensor dog is not hitting to the X
home sensor.
(3) Adjust the X home sensor dog or the X home sensor board position if the X home sensor dog is hitting to
the X home sensor.
Conrm the X home sensor dog is
not hitting to the X home sensor.
X home sensor
X home sensor dog
(4) Adjust the home position in the maintenance mode, after the X home sensor was reinstalled.