GRAPHTEC FCX2000 - Installing The Warning Light Option Oph-A40

FCX2000-UM-251-9370 2-12
2 Setup procedure
2.7.1 Installing the Warning Light Option OPH-A40
The bracket and cables for warning light is installing to the FCX2000 already for this option.
This option needs to install the Warning Light Assembly to the warning light bracket, and then it needs to
connect the warning light cable to the warning light relay cable.
Installing procedure
(1) Remove the four M4L6 binding head screws holding the left rear cover of warning light, and then detach
it.
M4L6 binding head screw
Left rear cover of warning light
(2) Remove the nut from the Warning Light assembly.
Remove the nut from the
warning light assembly.
(3) Insert the Warning Light to the Warning Light Bracket as shown in the picture below, and then x the
Warning Light by using a Nut.