FCX2000-UM-251-9370 8-48
8 DISASSEMBLY AND ASSEMBLY
(10) Move the Y bar to the far right and the far left several times, and then conrm the X belt is not touching
to the ange of X idler pulley.
Conrm the X belt is not touching
to the ange of X idler pulley.
Rear X belt
Flange of idler pulley
(11) Adjust the belt tensions if the belt is touching to the ange of X idler pulley.
(12) Apply a few quantity of the silicon grease to the X drive pulley if the belt is replaced.
Note:
Do not use grease other than the silicon-grease.
The other grease will be the cause of chemical damage to the belt.
(13) Tighten the two M4L6 binding head screw xing the idler bracket.
Idler bracket
Rear X belt
M4L6 binding head screw
M4L6 binding head screw
Rear X belt
Idler bracket
Use this access hole to loosen the screw of front.
To Next Page
Loading...
