FCX2000-UM-251-9370 8-70
8 DISASSEMBLY AND ASSEMBLY
(5) Remove the six M3L6 binding head screws holding the X Flexible Cable Bracket, and then detach it.
M3L6 binding head screw
X exible cable bracket
(6) Put the spacers to under the Y bar which has almost same height of Y bar.
This will prevent the Y bar drop when the xing screws of Y bar loosen.
Put the spacers to under the Y bar.
Front
Rear
(7) Loosen the three M4L8 cap screws and the four pan head cap screws holding the Y bar.
M4L8 cap screw
Front
M4L8 pan head cap screw
Rear
(8) Loosen the three M4L8 cap screws and the four pan head cap screws holding the Y bar.
(9) Adjust the Y bar height to up or down evenly at front and the rear.
Don’t lift up or down too much one side.
Otherwise the front Y bar bracket will bend.
(10) Tighten the three M4L8 cap screws and the four pan head cap screws after the Y bar height was
adjusted.
(11) Attach all parts which were detached.
To Next Page
Loading...
