GRAPHTEC FCX2000 - Page 158

FCX2000-UM-251-9370 9-12
9 ELECTRICAL ADJUSTMENTS
(7) Set the dip switch to each model settings as shown in the following table to set the normal mode.
Dip Switch 1 2 3 4 5 6 7 8 Model
12345678
ON
OFF
OFF OFF OFF OFF OFF OFF OFF OFF FCX2000-60
12345678
ON
OFF
ON OFF OFF OFF OFF OFF OFF OFF FCX2000-120
12345678
ON
OFF
OFF ON OFF OFF OFF OFF OFF OFF FCX2000-180
(8) Turn on the power for the FCX2000.
Note:
The NV-Flash ROM error will be displayed when the model of no NV-RAM Clear and the normal mode of
model is not matching.
Perform the NV-RAM Clear correctly if the NV-Flash ROM error was displayed.
The model of NV-RAM Clear and the model of normal setting must to be same.
(9) TheLanguageselectionmenuandtheLengthUnitselectionmenuaredisplayedattherstpoweron
(Refer to the section 9.8.).
(10) Select the Language and the Length Unit.
(11) Turn off the power for the FCX2000.