GRAPHTEC FCX2000 - Page 200

FCX2000-UM-251-9370 10-12
10 TROUBLESHOOTING
Error cord No. LCD Display Cause Solution
E04012 It has exceeded
detection area while
detecting the registration
mark for -X direction.
Conrm media position that is
inside of cutting area.
E04013 It has exceeded
detection area while
detecting the registration
mark for -Y direction.
Conrm media position that is
inside of cutting area.
E04014 It has exceeded
detection area while
detecting the registration
mark for +Y direction.
Conrm media position that is
inside of cutting area.
E04015 It has exceeded
detection area while
detecting the registration
mark for -Y direction.
Conrm media position that is
inside of cutting area.
E04016 It has exceeded
detection area while
detecting the registration
mark for -Y direction.
Conrm media position that is
inside of cutting area.
E04017 It has exceeded
detection area while
detecting the registration
mark
Conrm media position that is
inside of cutting area.
E04019 There was cancel
operation by the user.
Press the ENTER Key.
E04020 There is a defect in the
detection settings value.
Conrm the settings value.
E04021 The tool position was
not moved to the
rst registration mark
position.
Move tool position to the rst
registration mark position
before data is sending to the
plotter.
The registration mark
could not detect
automatically in the
detecting area.
The rst registration mark
should be positioned inside of
the cutting area.
E04022 There was cancel
operation by the user.
Press the ENTER Key.