FCX2000-UM-251-9370 8-19
8 DISASSEMBLY AND ASSEMBLY
How to reinstall the Front X Belt
(1) Open the Control Box (Refer to the section 8.1.17.).
(2) Loosen the four set screws holding the front X drive pulley.
There is front X drive pulley inside of X
drive pulley bracket.
Loosen the two M4L5 set screws holding the front X
drive pulley from this access hole.
Loosen the two M4L5 set screws holding the front X
drive pulley from this access hole.
(3) Shave 2 mm off ends of the X-belt until the wire comes out as shown below.
Shave this area until the wire comes out.
X belt
(4) Reattach the front X belt in the reverse order in which it was detached.
(5) Adjust the front X belt tension when installing the X belt (Refer to the section 8.4.3.).
(6) Apply a few quantity of the silicon grease to the belt and the tooth of pulley.
To Next Page
Loading...
