FCX4000-UM-251-9370 7-62
7 DISASSEMBLY AND ASSEMBLY
7.7.4 Electrostatic Adhesion Switch
How to detach the Electrostatic Adhesion Switch
(1) Detach the left front corner cover (Refer to the section 7.1.3.).
(2) Detach the left top cover (Refer to the section 7.1.6.).
(3) Detach the left side cover (Refer to the section 7.1.8.).
(4) Detach the front bottom cover (Refer to the section 7.1.17.).
(5) Disconnect the ES switch cable (J19) from the main board.
J5: Control panel cable
J18: ES power cable
J19: ES switch cable
Main board
(6) Release the cable ties holding the cables, and then pull out the ES switch cable from the left side main
frame.
Cable tie
Pull out the cables from here.
(7) Remove the two M3L6 binding head screws holding the Electrostatic Adhesion Switch assembly, and
then detach it from the tray.
M3L6 binding head screw
Electrostatic Adhesion Switch assembly
To Next Page
Loading...