GRAPHTEC FCX4000 - Error Messages In Gp-Gl Command Mode

FCX4000-UM-251-9370 9-8
9 TROUBLESHOOTING
9.4 Error Messages in GP-GL Command Mode
Error cord No. LCD Display Cause Solution
E02001
The plotter received
an unrecognizable
command.
Conrm the command
settings is not set to the
HP-GL.
Set the command settings to
the GP-GL.
E02004
A command was
received containing
numeric parameters that
exceed that command's
permissible range.
Conrm the command
settings is not set to the
HP-GL.
Set the command settings to
the GP-GL.
E02005
An error occurred in the
receipt of data within the
interface.
Conrm the command
settings is not set to the
HP-GL.
Set the command settings to
the GP-GL.
E02006
The data out of cutting
range has been
received.
Conrm the data.
Conrm the size of media and
the cutting range.
Conrm the step size settings.