GRAPHTEC FCX4000 - Operational Error

FCX4000-UM-251-9370 9-19
9 TROUBLESHOOTING
9.8 Operational Error
Error cord No. LCD Display Cause Solution
E05001
Data larger than the
buffer size cannot be
copied.
It can not use the copy mode.
E05002
There is no data to copy. Perform normal cutting by
sending the data, then use
the copy mode.
E05003
Media valid area to copy
is too small.
Use larger media.
Conrm the copy start
position.
E05006
Distance between the
bottom left and top right
of the AREA setting is
less than 10 mm.
Perform the AREA setting
again.
E05007
Test pattern for the TOOL
OFFSET ADJ. cannot
start plotting because
the start position is at the
edge of the media.
Set the start position inside
the media.
E05008
The external memory
(USB memory) is not
recognized.
Insert the external memory
(USB memory).
E05009
The bar code is not
detected.
Check at the printing state of
bar code and set the proper
bar code settings.
E05010
When the ROTATION is
enabled, the bar code
cutting function is not
available.
Set the ROTATION to
Disabled to use this bar code
cutting function.
E05011
When the REVERSE
CUTTING is enabled,
the bar code cutting
function is not available.
Set the REVERSE CUTTING
to Disabled to use this bar
code cutting function.
E05012
The appropriate le
cannot be found in the
external memory (USB
memory).
Save the appropriate le in
the external memory (USB
memory).
E05013
The START MARK is not
recognized.
Conrm the printing state of
bar code.
Move the tool carriage to the
START MARK.