FCX4000-UM-251-9370 8-40
8 ELECTRICAL ADJUSTMENTS
8.17 About Start Up Mode
It starts up in each start mode when starting while pressing the key to the table below when the power supply
is turned on.
Key Mode Remark
Upper arrow Setup Clear The cutting conditions are returned to the factory set-
ting. If your customer is changing conditions, you
should print out the condition list before performing this
mode.
Right arrow + left arrow Systemrmwareupdate
Slow + ENTER Maintenance Mode Electrical adjustment mode.
Lower arrow + ENTER Adjustment copy mode Copy the adjustment values from the Sub-NVRAM to
the Main board.
To Next Page
Loading...