GRAPHTEC FCX4000 - Y Flexible Cable

FCX4000-UM-251-9370 7-40
7 DISASSEMBLY AND ASSEMBLY
7.3.8 Y Flexible Cable
How to detach the Y Flexible Cable
(1) Detach the Y bar cover (Refer to the section 7.1.13.).
(2) Detach the rear Y bar end cover (Refer to the section 7.1.16.).
(3) Disconnect the Y Flexible cable from the Y relay board.
Y relay board
Y exible cable
(4) Disconnect the Y Flexible cable from the pen board.
Y Flexible cable
Pen board
(5) Gently peel off the Y Flexible cable from the Y bar and the Y cable bracket.
How to reinstall the Y Flexible Cable
(1) Reattach the Y exible cable in the reverse order in which it was detached.
(2) Move the pen block to front end of Y bar until it hit to the front stopper.
5 mm
(3) Make the 5 mm slack between the turning end of Y exible cable and the pen board as shown in above
picture.