GRAPHTEC FCX4000 - Adjusting The Home Position

FCX4000-UM-251-9370 8-15
8 ELECTRICAL ADJUSTMENTS
8.9 Adjusting the Home Position
Perform this procedure if adjustment values could not copy from the SUB-NVRAM when replacing the main
board or if the position of home sensor was changed or the position of home position dog was changed.
This function will adjust the home position for the FCX4000.
Note:
ConrmtheCondition1oftoolsettingissettoTool1atnormalmode.Andselectthecondition1atnormal
mode, before the home position adjustment. The home position have to adjust by the position of
Tool 1.
How to adjust the home position
(1) Turn on the power while pressing the Slow and the ENTER keys.
(2) Press the PAUSE/MENU key at the following menu.
(3) The following menu is displayed, and then press the RIGHT ARROW key (ADJ).
(4) The following menu is displayed.
(5) Press the UP ARROW key to display the following menu.