GRAPHTEC FCX4000 - Rear Bottom Cover

FCX4000-UM-251-9370 7-8
7 DISASSEMBLY AND ASSEMBLY
7.1.12 Rear Bottom Cover
How to detach the Rear Bottom Cover
(1) Detach the right rear corner cover (Refer to the section 7.1.2.).
(2) Detach the left rear corner cover (Refer to the section 7.1.4.).
(3) Detach the left top cover (Refer to the section 7.1.6.).
(4) Detach the rear top cover (Refer to the section 7.1.10.).
(5) Detach the X exible cover (Refer to the section 7.1.11.).
(6) Disconnect the X Flexible cable from the main board and release the X exible cable from the cable tie.
X Flexible cable
Cable tie
(7) Remove the ve M4L8 binding head screws holding the bottom of rear bottom cover for the FCX4000-
60.
Remove the three M4L8 binding head screws holding the bottom of rear bottom cover for the FCX4000-
50.
(8) Remove the four M4L8 ange cap screws holding the each side of rear bottom cover.
M4L8 binding head screw
Rear bottom cover
M4L8 ange cap screw
M4L8 ange cap screw
(9) Detach the rear bottom cover.
(10) Detach the X exible cable from the rear bottom cover.