GRAPHTEC FCX4000 - Selecting The Tool Condition Number

FCX4000-UM-251-9730 3-17
3.
OPERATIONS
3.7.1 Selecting the tool condition number
Eight settings (1 to 8) as the tool condition can be stored. By switching this setting, it can be switched to 8
types of label material-specic settings that have been set previously.
Operation Method: Operation with the [COND/TEST] key
(1) Press the [COND/TEST] key from READY status.
CONDITION setting screen (1/4) is displayed.
(2) Press the [1] key.
CONDITION No. selection screen is displayed.
(3) Press the POSITION (▲▼) keys and select the setting.
(4) Conrm the setting and press the [ENTER] key.
Setting will be set, and it will return to CONDITION screen (1/4).
(5) Press the [COND/TEST] key.
It will return to default screen.
Operation Method: Operation with the [ENTER] key
(1) Press the [ENTER] key from READY status.
CONDITION No. selection screen is displayed.
(2) Select the CUT CONDITION (Tool Condition) by pressing one of [1] to [4] key or using the POSITION
(▲▼▲▼) keys while holding down the [ENTER] key. (The selected item is highlighted.)
(3) Conrm the setting and release the [ENTER] key.
It will return to default screen.