GRAPHTEC FCX4000 - Tray Assembly

FCX4000-UM-251-9370 7-13
7 DISASSEMBLY AND ASSEMBLY
7.1.18 Tray Assembly
How to detach the Tray Assembly
(1) Detach the right front corner cover (Refer to the section 7.1.1.).
(2) Detach the left front corner cover (Refer to the section 7.1.3.).
(3) Detach the left rear corner cover (Refer to the section 7.1.4.).
(4) Detach the right top cover (Refer to the section 7.1.5.).
(5) Detach the left top cover (Refer to the section 7.1.6.).
(6) Detach the left side cover (Refer to the section 7.1.8.).
(7) Detach the front top cover (Refer to the section 7.1.9.).
(8) Detach the front bottom cover (Refer to the section 7.1.17.).
(9) Disconnect the control panel cable, the ES power cable and the ES switch cable from the main board.
J5: Control panel cable
J18: ES power cable
J19: ES switch cable
Main board
(10) Release the cable ties holding the cables, and then pull out the cable from the left side main frame.
Cable tie
Pull out the cables from here.
(11) Disconnect the ES power cable from the relay connector of the ES high voltage board.
ES power cable