GRAPHTEC FCX4000 - X-Axis Drive Part; Motor

FCX4000-UM-251-9370 7-15
7 DISASSEMBLY AND ASSEMBLY
7.2 X-Axis Drive Part
7.2.1 X Motor
How to detach the X Motor
(1) Detach the right top cover (Refer to the section 7.1.5.).
(2) Disconnect the X motor power cable from the X motor power relay connecter.
(3) Disconnect the X motor encoder cable from the X motor.
X motor encoder cable
X motor power cable
X motor
(4) Remove the three M3L6 ange cap screws holding the X motor, and then detach it.
M3L6 ange cap screw
X motor
(5) Detach the core from the X motor encoder cable.
(6) Loosen the two M3L5 set screws holding the X motor pulley, and then detach it.
M3L5 set screw
X motor
X motor pulley