GRAPHTEC FCX4000 - Flowchart Of The Adjustment Sequence; The Main Board Was Replaced (Normal Procedure)

FCX4000-UM-251-9370 8-2
8 ELECTRICAL ADJUSTMENTS
8.2 Flowchart of the Adjustment Sequence
Flowchart of the Adjustment Sequence for the FCX4000 series.
8.2.1 The main board was replaced (Normal procedure)
When the main board was exchanged, copy adjustment values to the main board from the SUB-NVRAM by
the following procedure.
8.5 Updating the System Firmware
8.4 Set the dip switch for corresponding model
8.8 Install the SUB-NVRAM to the new main board
8.8 Copy the adjustment values from the SUB-NVRAM to main board
8.6 Clearing the Non-Volatile RAM for corresponding model
8.8 Remove the SUB-NVRAM from previous main board
End of Main Board replacement