GRAPHTEC FCX4000 - The Pen Block Was Replaced; The X Home Sensor Was Replaced; The Y Home Sensor Was Replaced; The Registration Mark Sensor Was Replaced

FCX4000-UM-251-9370 8-4
8 ELECTRICAL ADJUSTMENTS
8.2.3 The pen block was replaced
When the pen block was exchanged, perform the following adjustments.
8.9 Adjusting the Home Position
8.10 Adjusting the Pen Force
8.12 Adjusting the Tool Interval
8.13 Adjusting the Registration Mark Sensor Sensitivity
8.14 Adjusting the Offset of Registration Mark Sensor
End of Adjustment
8.2.4 The X home sensor was replaced
When the X home was exchanged, perform the following adjustments.
8.9 Adjusting the Home Position
End of Adjustment
8.2.5 The Y home sensor was replaced
When the Y home was exchanged, perform the following adjustments.
8.9 Adjusting the Home Position
End of Adjustment
8.2.6 The registration mark sensor was replaced
When the registration mark sensor was exchanged, perform the following adjustments.
8.13 Adjusting the Registration Mark Sensor Sensitivity
8.14 Adjusting the Offset of Registration Mark Sensor
End of Adjustment