GRAPHTEC FCX4000 - Rear X Belt

FCX4000-UM-251-9370 7-23
7 DISASSEMBLY AND ASSEMBLY
7.2.4 Rear X Belt
How to detach the Rear X Belt
(1) Detach the right rear corner cover (Refer to the section 7.1.2.).
(2) Detach the left rear corner cover (Refer to the section 7.1.4.).
(3) Detach the left top cover (Refer to the section 7.1.6.).
(4) Detach the rear top cover (Refer to the section 7.1.10.).
(5) Detach the X exible cable cover (Refer to the section 7.1.11.).
(6) Detach the rear bottom cover (Refer to the section 7.1.12.).
(7) Remove the seven M3L6 binding head screws holding the rear X belt cover, and then detach it.
M3L6 binding head screw
Rear X belt cover
(8) Mark the position of X belt tension bracket before loosing the screws of the X belt tension bracket as
shown in the picture below.
Rear X belt tension bracket
Mark the position of X
rear belt tension bracket.
Rear X belt tension bracket
Mark the position of rear
X belt tension bracket.