GRAPHTEC FCX4000 - Setting The Tool Condition

FCX4000-UM-251-9730 3-18
3.
OPERATIONS
3.7.2 Setting the Tool Condition
This section describes how to make the tool, speed, force, acceleration, and tool number settings.
Before cutting media, the following four cutter pen conditions must be specied.
• OFFSET
• SPEED
• FORCE
• ACCELERATION
Setting the Tool
(1) Press the [COND/TEST] key from READY status.
CONDITION setting screen (1/4) is displayed.
(2) Press the [2] key (TOOL).
TOOL setting screen is displayed.
(3) Press the POSITION (▲▼) keys, and set the tool.
(4) Press the [3] key (OFFSET).
OFFSET setting screen is displayed.
(5) Press the POSITION (▲▼) keys and increase or decrease the setting value.
(6) Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/4).
(7) Press the [COND/TEST] key.
It will return to default screen.