GRAPHTEC FCX4000 - 3 Basic Operation; How To Use The Control Panel

FCX4000-UM-251-9730 3-1
3.
OPERATIONS
3. Basic Operation
3.1 How to Use the Control Panel
This section explains the function of lamps and keys on the control panel.
[ENTER] key
[SLOW] key[1, 2, 3, 4] key POSION
(
, , , )
key
Screen (LCD) [COND./TEST] key
[ESC] key
[COPY] key
[ORIGIN] key
ORIGIN lampUSER 1/2 lamp
[PAUSE/MENU]
lamp
[PAUSE/MENU] key[USER1/2] key
Indicator Lamp
USER 1/2 lamp ..........................User lamp that has been selected lights.
PAUSE/MENU lamp ..................Lights at the time of the menu mode.
ORIGIN lamp .............................When the origin point has been saved, the lamp lights.
Control key
USER 1/2...................................Switches the user selection.
PAUSE/MENU ...........................Switches to the MENU mode.
It will go into MENU mode if the key is pressed once, and MENU mode will
be turned off when the key is pressed again.
Various functions are set in the MENU mode.
When the PAUSE/MENU key is pressed during the operation, the cutting/
plotting operation stops.
ORIGIN ......................................Sets the current position as an origin point.
On the READY screen, pressing the [ENTER] and [ORIGIN] keys at the
same time will allow you to reset the plotter.
COPY ........................................Copy of data in the buffer memory is output.
ESC ...........................................Cancels the setting change and then returns to the previous screen in the
setting screen. Returns to the previous screen in the menu screen.
ENTER ......................................Saves the settings, and then returns to the setting screen in various functions
and condition setting screen of the menu screen.
On the READY screen, pressing the [ENTER] and [ORIGIN] keys at the
same time will allow you to reset the machine.
COND/TEST ..............................Displays the screen to set the tool conditions.
Use this when checking tool conditions to activate a cutting test.