GRAPHTEC FCX4000 - Y-Axis Drive Part; Y Motor

FCX4000-UM-251-9370 7-31
7 DISASSEMBLY AND ASSEMBLY
7.3 Y-Axis Drive Part
7.3.1 Y Motor
How to detach the Y Motor
(1) Detach the rear Y bar end cover (Refer to the section 7.1.16.).
(2) Disconnect the Y motor
power
cable from the Y motor power relay connector.
Disconnect the Y motor encoder cable from the Y motor.
Y motor power relay connector
Y motor encoder cable
Y motor
(3) Remove the Three M3L6 binding head screws holding the Y motor assembly, and then detach it.
M3L6 binding head screw
(4) Remove the Three M3L6 binding head screws holding the Y motor bracket, and then detach it.
Y motor
Y motor bracket
M3L6 binding head screw