GRAPHTEC FCX4000 - Attaching A Tool

FCX4000-UM-251-9730 3-14
3.
OPERATIONS
3.5 Attaching a Tool
How to attaching
(1) Loosen the tool holder screw.
Tool holder
Bracket to hold tool
Tool holder screw
(2) While pushing up the tool holder, push the tool into the holder until its ange completely touches the
upper part of the holder.
Bracket to hold tool
Flange
Tool holder
Tool
(3) Make sure that the tool bracket is engaged on the tool's ange, and then tighten the screw.
Flange
Bracket to hold tool
Tool holder screw