FCX4000-UM-251-9370 7-36
7 DISASSEMBLY AND ASSEMBLY
7.3.4 Y Home Sensor Board
How to detach the Y Home Sensor
(1) Detach the Y bar cover (Refer to the section 7.1.13.).
(2) Detach the front Y bar end cover (Refer to the section 7.1.15.).
(3) Disconnect the Y home sensor cable from the Y home sensor board.
(4) Remove the two M3L6 binding head screws holding the Y home sensor board, and then detach it.
M3L6 binding head screw
Y home sensor board
Y home sensor cable
How to reinstall the Y Home Sensor Board
(1) Reattach the Y home sensor board in the reverse order in which it was detached.
(2) Move the pen block to the Y home sensor position, and then conrm the Y home sensor dog is not
hitting to the Y home sensor.
(3) Adjust the Y home sensor dog or the Y home sensor board position if the Y home sensor dog is hitting to
the Y home sensor.
Conrm the Y home sensor dog is
not hitting to the Y home sensor.
Y home sensor
Y home sensor dog
(4) Adjust the home position in the maintenance mode, after the Y home sensor was reinstalled.
To Next Page
Loading...