FCX4000-UM-251-9370 8-19
8 ELECTRICAL ADJUSTMENTS
(6) Press the F2 key (PEN FORCE ADJUST) to display the following menu.
(7) Press the F2 key (MANUAL) to display the following menu.
Don’t press the F1 (AUTO with gauger), this mode is used at production line only.
(8) Move the tool position to anywhere to measure the pen force easily, and then press the ENTER key.
Press the ENTER key without moving the position if you are going to input the adjustment values from
the factory adjustment label.
(9) The following menu is displayed.
To Next Page
Loading...