GRAPHTEC FCX4000 - Page 134

FCX4000-UM-251-9370 8-23
8 ELECTRICAL ADJUSTMENTS
(9) WhentheRIGHTARROWkeyispressed,thedrawingpatternsizeisabletoselect.
PresstheF1orF2toselectthedrawingsize.
Thefollowingmenuisdisplayedafterthedrawingsizewasselected.
When inputting the recorded values
(10) If you have replaced the main board only, use the recorded values (The recorded values of X, Y, XY(Z).
Thesevaluesweremeasuredbasedonthe400x300size.).
Press the F2 key (X=) to input the X-axis distance adjustment value.
Press the ENTER key to set value.
Press the F3 key (Y=) to input the Y-axis distance adjustment value.