FCX4000-UM-251-9370 8-35
8 ELECTRICAL ADJUSTMENTS
(10) Press the F2 key (SCAN). The following menu is displayed.
(11) Use the Position keys to move the pen position to the printed cross mark area shown below.
Media feed
direction
10 mm
Printed target mark
Move the pen position into this area.
10 mm
Note: Position the pen-tip to the area above. Do not position the RMS sensor to the area above.
(12) Press the ENTER key after positioned the pen-tip.
(13) The plotter scans the printed cross mark and then the plotter then plots a new cross mark based on the
reading of the printed cross mark.
The following menu is displayed.
To Next Page
Loading...