GRAPHTEC FCX4000 - Page 162

FCX4000-UM-251-9370 9-10
9 TROUBLESHOOTING
Error cord No. LCD Display Cause Solution
E03013
A parameter outside of
the permissible range
was specied in the I/O
related command.
This error will not display if
the application software was
programed correctly.
Conrm this to the vender of
application software.
E03014
Too many parameters
in the I/O related
command.
E03015
Framing error, parity
error, or overrun error
has occurred.
Conrm the condition of
RS-232C communication
settings.
Conrm the cable wiring
of RS-232C.
Set same RS-232C
communication settings on
the PC and plotter.
Use genuine Graphtec RS-
232C cable.
E03016
Interface buffer memory
has overowed.
Conrm the condition of
RS-232C communication
settings.
Conrm the cable wiring
of RS-232C.
Set same RS-232C
communication settings on
the PC and plotter.
Conrm the handshake
setting for the RS-232C.
Use genuine Graphtec RS-
232C cable.