FCX4000-UM-251-9370 9-12
9 TROUBLESHOOTING
Error cord No. LCD Display Cause Solution
E04012
It has exceeded
detection area while
detecting the registration
mark for -X direction.
Conrm media position that is
inside of cutting area.
E04013
It has exceeded
detection area while
detecting the registration
mark for -Y direction.
Conrm media position that is
inside of cutting area.
E04014
It has exceeded
detection area while
detecting the registration
mark for +Y direction.
Conrm media position that is
inside of cutting area.
E04015
It has exceeded
detection area while
detecting the registration
mark for -Y direction.
Conrm media position that is
inside of cutting area.
E04016
It has exceeded
detection area while
detecting the registration
mark for -Y direction.
Conrm media position that is
inside of cutting area.
E04017
It has exceeded
detection area while
detecting the registration
mark
Conrm media position that is
inside of cutting area.
E04019
There was cancel
operation by the user.
Press the ENTER Key.
E04020
There is a defect in the
detection settings value.
Conrm the settings value.
E04021
The tool position was
not moved to the
rst registration mark
position.
Move tool position to the rst
registration mark position
before data is sending to the
plotter.
The registration mark
could not detect
automatically in the
detecting area.
The rst registration mark
should be positioned inside of
the cutting area.
E04022
There was cancel
operation by the user.
Press the ENTER Key.
To Next Page
Loading...