FCX4000-UM-251-9370 9-14
9 TROUBLESHOOTING
Error cord No. LCD Display Cause Solution
E04025
Registration mark was
not detected.
There is no registration
mark.
Readjust the registration
sensor level.
Do not use the laminate.
The sensor could not detect
the registration mark if the
base color and the registration
mark has too much reection.
The registration mark
sensors were not
adjusted after the main
board or the registration
mark sensors are
replaced.
Adjust the registration mark
sensors sensor level in the
maintenance mode.
The registration mark
sensor is defective.
Replace the registration mark
sensor when the adjusting
level does not become to 45
to 55% in the maintenance
mode.
To Next Page
Loading...